Open the General Event Settings dialog to perform all event control settings such as camera activity, dead times, delays and storage settings.
Note: | Click on the More button to display all options of the dialog. |
---|
Option | Parameters | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|
Arming |
When you deactivate arming permanently or temporarily, events will continue to be recognized (and highlighted in the image symbols) but they will not be processed any further. Consequently, the images are not stored, the event counter is not incremented and neither actions nor messages are performed.
|
||||||||||
Time Table Profile |
In order to arm the camera in a time-controlled manner, you need to select a Time Table Profile. You need to enable arming. The Time Table Profile can also be combined with arming via signal-input. |
||||||||||
Flashing LEDs |
This parameter controls the flashing of the camera LEDs that have been set to Event in the LED Setup dialog.
|
||||||||||
Blinking LEDs |
This parameter provides numerous options for controlling the blinking (slower than flashing) of the camera LEDs that have been set to Event in the LED Setup dialog. The default setting is Blink on recording. |
Click on the Set button to activate your settings and to save them until the camera is rebooted.
Click on the Close button to close the dialog. While closing the dialog, the system checks the entire configuration for changes. If changes are detected, you will be asked if you would like to store the entire configuration permanently.